Page 1 of 1

External contacts using

PostPosted: 03 March 2020, 16:12
by support
Image

Connect the external switch #1 to "pin 1" and "COM" to trigger the standalone scene #1.
Connect the external switch #2 to "pin 2" and "COM" to trigger the standalone scene #2
...
Connect the external switch #8 to "pin 8" and "COM" to trigger the standalone scene #8.

Re: External contacts using

PostPosted: 22 April 2020, 08:47
by support
Important
In order to avoid bounce, you have to add a 100nF capacitor as close as possible to the switch device.

Image

Re: External contacts using

PostPosted: 07 June 2021, 07:53
by support
In case of you need more than 8 external contacts, 8 more are available from an unassembled 2*5 pins connector inside the interface (on the front panel pcb).
Image