Page 1 of 1

EZ-kling

PostPosted: 10 January 2017, 15:42
by BartKrap
Hey support,

I was wondering if I could convert the 2nd artnet universe to dmx using the Adj/Elation EZ-Kling?

http://www.americandj.eu/nl/ez-kling.html

Greets

Re: EZ-kling

PostPosted: 10 January 2017, 19:15
by support
No, this is not possible.

Re: EZ-kling

PostPosted: 15 January 2017, 15:15
by BartKrap
support wrote:No, this is not possible.

Could you explain to me why this would not be possible, because looking at the specs it should be able to.

Re: EZ-kling

PostPosted: 15 January 2017, 18:22
by support
We just read the main specifications, then it was our conclusion. May be we made a mistake (we never used this device). We can only say our software sends Artnet commands.
If the manual of this device says: "receive Artnet and sends dmx", then it should be ok.
Sorry for our misunderstanding.

Re: EZ-kling

PostPosted: 15 January 2017, 20:58
by BartKrap
support wrote:We just read the main specifications, then it was our conclusion. May be we made a mistake (we never used this device). We can only say our software sends Artnet commands.
If the manual of this device says: "receive Artnet and sends dmx", then it should be ok.
Sorry for our misunderstanding.

Thank you, yes this device can recieve artnet and convert it into dmx signals, I am going to test this soon and will let you know what the results are so you can better help other people that might get this device.

Re: EZ-kling

PostPosted: 19 January 2017, 09:09
by BartKrap
Hey support, a little help needed here.

We can't get it to work right. Can you confirm we should go to: preferences --> Hardware --> autodetect network devices ?

Re: EZ-kling

PostPosted: 19 January 2017, 09:40
by support
So far, "autodetect network devices" does not exist.
"Autodetect interfaces" is to find our Ethernet dmx interface (viewtopic.php?f=86&t=4664).

For Artnet please watch this: https://www.youtube.com/watch?v=mHrl4Q5kXp8