Page 1 of 1

to know

PostPosted: 06 May 2015, 07:12
by support
To enable Artnet control with our software, the software has to find one of these interfaces: dmx interfaces.
Then the Artnet signal is sent via the Ethernet port of the computer.

To setup the Artnet parameters, please follow this:
https://www.youtube.com/watch?v=mHrl4Q5kXp8
https://www.youtube.com/watch?v=JISeyVcqXvs&
https://www.chauvetdj.com/wp-content/up ... ML6_WO.pdf