Page 1 of 1

Standalone audio activation

PostPosted: 29 May 2015, 19:41
by kikih
Hi, I've just installed a Quick DMX 512 controller as a replacement for a faulty controller in a Night Club. The controller is running in standalone operation, I have two questions,
1: Is there anyway to connect an audio source in order for some of the programmes to run "sound to Light"
2: The supplied remote has 18 buttons, but I could only programme shows on to the first 12, buttons 13 to 18 wouldnt call up any saved shows.

Regards, Kieran.

Re: Standalone audio activation

PostPosted: 30 May 2015, 08:52
by support
1. sorry but the standalone interface does not have any audio input

2. please post (or email) your lightshow ; we will check it