When we do the lightshows we’ll first check it with the 3D Animation. If we see faults we set the red mark and jump back to this point. Lights go off for a moment and will be back after a few seconds. All fine.
In the new version Lights still stays off and no DMX Output is created.
Only if we jump to a point where a scene starts it will work.
The is a problem because we do a lot of lightshows for theatres and when we use Moving Heads/Wash we drive the devices to the right Position, select Colours, Gobos, Zoom in an earlier scene, before we let them fade in.
So if we want to check we have to jump back and back and back…..
I hope you’ll understand my problem?
greatings