Calibrate moving heads in generator [fixed]

create scenes with shape generator

Calibrate moving heads in generator [fixed]

Postby Pauluzzz » 20 September 2018, 06:52

One of my moving heads fell on the floor and luckily it did not break apart, the only damage is that the head now starts a few degrees to the left when it switches on in comparison to its brothers. Before opening it up and attempt to repair it (likely destroy it forever), is there a way that I can offset the head so that it is in sync again? Like adding automatically a couple points extra into the X channel for this fixture when building a curve so it gets an extra push? Thanks.
Pauluzzz
 
Posts: 36
Joined: 01 June 2018, 06:28

Re: Calibrate moving heads in generator

Postby support » 20 September 2018, 07:42

The Lighting Controller
support
Administrateur
 
Posts: 10538
Joined: 07 December 2009, 16:32


Return to Editor - Generator

Who is online

Users browsing this forum: No registered users and 3 guests

cron