DMX512 Decoder addressing second decoder
Posted: 08 January 2021, 17:20
***Complete Beginner***
I’m using an Xpress512S interface and a PC with Showxpress software. I’m programming two 24 channel decoders. The first decoder works fine with 8 RGB led strips with decoder dip switch set to channel number 1. I have the second decoder dip switch set to channel 25 and can’t get any lights to turn on using the fader. DMX blinking light shows active on both decoders. I built 16 separate RGB fixtures starting on channel one in showxpress.
Sorry if this is an obvious question.
I’m using an Xpress512S interface and a PC with Showxpress software. I’m programming two 24 channel decoders. The first decoder works fine with 8 RGB led strips with decoder dip switch set to channel number 1. I have the second decoder dip switch set to channel 25 and can’t get any lights to turn on using the fader. DMX blinking light shows active on both decoders. I built 16 separate RGB fixtures starting on channel one in showxpress.
Sorry if this is an obvious question.