Nothing out from standalone.

[linsan]

Hi.
Maybe i´m stupid and have not read the manual but i can´t get standalone-mode to work.
I have a Box that i bougt a couple years ago and running in XP.
Sweetligt v6
When i upload a scene to the box my scanners reset and then nothing happens.
The software says: Upload succeded or something like that.
The box goes to standalone mode (green light) when i shut down the software or power it up.
But nothing happends to the fixtures.
I have a dmx-splitter that indicates theres dmx-signal through.
When i upload the standalonescene it shows: Universe 1 Box (V2)
Is there a firmware update in the hardware?
All the drivers and the software is downloaded from your site last week so i figure it´s the latest.

[support]

There is no new driver for Box, for several years.
Software from last week is ok.
Please confirm you are uploading a scene with less than 100 channels (no active channels above channel 100).

[linsan]

I have tried to make a simple scene flashing dimpacks on DMXchannel 1,2,3 only but it´s the same result when i upload it.

[WALLISERHOF]

Hi, just had the same problem. Worked with Win XP and software 5,4. V6 doesnt work with BOX.
Regards from austria

[support]

Please check you double-click the wanted scene in the scenes list, in order to see its name below the list, before clicking on "Upload".