It seems i always post when it's critical to have my issue resolved. There is a show that I'm LD'ing tomorrow and my DMX512's or my software is corrupted. If I use either interface by itself in single universe mode, they each operate fine. When I use both in 2 Universe Mode, they do not work. In fact, the last light in my chain on the second universe is triggered.
I have been operating with both interfaces for several weeks now, and in fact ran a show on Wednesday night. When I came in for a show on Friday and booted up, I had the issue.
I think I'm now forced to operate on one Universe, which works fine, but all of my programming is lost because unfortunately, all of my movers were programmed on the second universe. I have not found a way to import any of the scenes to the single universe I have set up with identical addressing for the movers.
As I mentioned, each Interface works fine by itself in single universe mode. They do not work together when I'm set up for 2 universes and triggering a scene from the first universes, sends a signal through the second to the last light.
I failed to mention, the lights work fine in the 3D Visualizer with 2 universes so I am stumpted.
I completely uninstalled and reinstalled the software and that did not help. I've used different USB ports and that did not help. I would hate to have to reprogram this show as it starts tomorrow at three and I will not have access to the venue until about 2 hours before load in. Does anyone have any ideas??