Fixture snap issue with multi fixture bars [fixed]
Posted: 07 October 2018, 17:58
Hello, I am trying to create bars such as ADJ Dotz Tpar or Cameo Hydrabeam 4000. They appear as linked on 3D but in a rather random position, not a really as a bar, so I started doing it manually.
I adjusted pars and moving heads sizes.
Then I unchecked the "autoselect multihead" to position them to create 1meter bars. This is where the problem is, however they keep on adjusting positions to snap to whatever is close (next bar member or truss) where they disappear. e.g. almost impossible to place them 40cms from each other. I tried to do this in an isolated place of the room, nothing better.
Is theere a way I can disable or tune this snap behavior ?
Pat
I adjusted pars and moving heads sizes.
Then I unchecked the "autoselect multihead" to position them to create 1meter bars. This is where the problem is, however they keep on adjusting positions to snap to whatever is close (next bar member or truss) where they disappear. e.g. almost impossible to place them 40cms from each other. I tried to do this in an isolated place of the room, nothing better.
Is theere a way I can disable or tune this snap behavior ?
Pat