Hello,
I'm using the latest version of Showdesigner, 6.22.
As I already had with version 5, I have a problem with my Showtec Phantom's. I use them by two, symmetrically placed, one of them pan reversed.
In the Setup, i can't say "clone = 2 but one is pan reversed" so I need to create two fixtures, one with pan reversed. So I address the same DMX channel for both, so I can control them both, and everything's fine.
But in the 3D section, there's only one fixture which react, the other one stays "off"...
How can we do this?
PS: in version 5, i tried to create the second on another DMX channel, then group them into the editor, but it is quite boring to use it this way.
Thanks!