Last night-gig, after 5 ours of using sweetlight, again lights gone.
Kept a better eye on it, since in didn't change the light-show which i put in dropbox for you, and expected it to happen again. It did.
It's when i pushed the 3 or 4th macro dedicated button on my 1ste APCmidi controller that suddenly al lights went out.
I'm not sure if it's the third of 4th round button, since i'm DJ'ing meanwhile.
But i'm sure it's around that area of buttons on my 1st APC mini where my fingers were. It happens every weekend-gig. Frustrating.
Like before, the application didn't crash, i was able to normally stop it, en started it again. Light worked immediately again.
I took a look in the folder, and saw a 'livi.ini.old' was created again.
I had to DJ two more hours before the party was finished. No problems again with the software during those two last hours.
Then, when the club was empty, i started pushing al the buttons in that area in every way i could think of. Light touch, hard touch, intentional two buttons at the same time, on the side of the button, fast touch, long touch... I 'abused' the buttons in the most dummy way i could think of, but couldn't reproduce it.
So there is nothing wrong with the APC mini i would think.
Damn, damn, damn, so frustrating.
Now at home, i started to have a look at all the scenes that are triggered by macro 3 and 4.
I noticed some of them are still
.sce extensions instead of the new
.scex .Could that have something to do with it?
support wrote:With a bug of our software, restarting our software is enough (sometimes restarting the interface is necessary to).
Ok, thanks.
support wrote:We did not check all lines of your 'live.ini" file. If it is corrupted, you will see it when pressing the corresponding button.
It's the third or fourth macro button. Tomorrow i have another gig. I will try to have a more accurate look which is difficult because i'm DJ'ing at the same time and want to have my light's asap running again after such a blackout.
But i'm 90% sure it's the third macro. which i used several times in the first ours, and as i said, 'abused' afterwards.
Sot let's assume it's the third macro, what to do now?
support wrote:"live.ini.old" is created, just is case of. You do not have to care of it.
ok.
I could go back to the date of 23 oktober when i wrote this:
Bonifacedj wrote:Just used V8.1.29 for more than 10 hours. Conclusion: STABLE!
thx.
I took a back up of my light-show after that gig. So i can go back.
But is that the solution?
Since then, i only made two more button boards preparing for my
two new ADJ Vizi Beam RXONE which a received yesterday and tested this morning in the empty club. Still experimenting where the best position is relative to my mirror ball, but they are amazing and i'm already thinking of buying two more, See picture.
But what to do with this trouble with my lightshow software now. I'm stuck. Don't know what to do
Looking forward to your answer.
Thanks already for all your support.
[image]